Perfect Union banner

sling swivels for 1.25 sling?

2K views 7 replies 6 participants last post by  marine one 
#1 ·
I found a very nice leather Springfield Armory sling. Bought it at discount. Got it home and discovered that it was not going to fit without lots of effort and oil. Managed to put the long loop together but can't fit the frog or the doubled portion and d ring through the d ring at the butt.

Can anyone suggest a set of swivels/d rings that I can use to replace the factory hardware to accept this 1.25 sling?

Thanks much.
 
#3 ·
Thank, George.

That I can do.

It appears the front d-ring is attached to the gas block with no visible screw. Have you or anyone suggestions on how to make the substitution. I think I can figure out the rear sub.

BTW, welcomem home, Bro.

Doc.
 
#4 ·
Uncle Mike's might make a QD swivel for that. The factory one is pressed in. Its either that or drill a hole in the forearm, under the liner, and mount one there. Make sure it doesn't interfere with the oprod.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top