Perfect Union banner
1 - 8 of 8 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
FS: One (1) Ruger Factory 20 rd Mini-14 mag. Mag is in VG-Ex used condition. Ruger marked baseplate, no Ruger marking on mag body.

$75 + $5 shipping to lower 48 states in U.S.

Shipping will be by USPS Priority Mail. Upgraded shipping available at your cost. I will only ship to hi-cap friendly states.

I don't have a digital camera, so sorry no pics are available. This mag is in good solid shape mechanically and has nearly 100% finish. It does have some light surface rust but should clean up nicely.

E-mail me direct at Trebor1415 at hotmail.com (replace "at" with "@")

I'm new on this forum, but I'm active as Trebor on the Fal Files at www.fnfal.com if you want to check me out. (As well as other forums).
 

· Registered
Joined
·
9,633 Posts
Welcome to the forum Trebor. Am moving your thread to the Magizine section, but leaving a redirect here for better coverage.
Welcome aboard.
 

· Registered
Joined
·
108 Posts
Hey Trebor,
If you get no takers, you may want to try GunBroker.com where, lots of folks bid on things. You have to register and all that but hey, lots of people visit that site on a dialy basis like me :D Good Luck!

Larry
 

· Registered
Joined
·
5 Posts
Discussion Starter · #5 ·
Canjungeo,

Thanks for the move and redirect. I wasn't entirely sure were to post this.

Tady,

Thanks for the suggestion. I'll leave it up here to after the holidays, and then I'll look into the auction sites. Can't believe no one here wants a factory mag. Hope I didn't scare people off mentioning the really light rust spots, but I want to be honest.

Trebor
 

· Registered
Joined
·
5 Posts
Discussion Starter · #8 ·
Ruger Factory mag is sold.

I do have two (2) 20 round aftermarket mags available in Exc condition. I don't know the manufacturer, but they are NOT USA mags (I know what those look like).


$35 for both, including shipping.

Trebor
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top