Perfect Union banner
1 - 1 of 15 Posts

· Registered
39 Posts
Screw direction?

Just curious about what tri70 brought up. You SHOULDN'T be able to put the screws in upside down, since only the screw holes in the upper half of the gas block are threaded...but, in that one photo it DOES kinda look like a screw head protruding from the top half. Hard to tell from that angle, though.

I suppose that if one put the screws in right side up on one side, and then put the screws in upside down on the other, and gravity held them in place until the rifle was fired, that might cause the unsupported upside down ones to shear...maybe. Or maybe I need new glasses.
1 - 1 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.