Joined
·
64 Posts
dear friends,
i own a walther/umarex colt M4 clone in .22 l.r. and also a walther HK 416 clone in .22 l.r.
in the manual of the walther/umarex M4 colt clone i can read that it is a MUST to loosen the flashhider some turns before starting to drive out the reward take down pin for further disassembly.
in the manual of the walther/umarex HK 416 clone in .22 l.r. i can't find a passage that's recommending to loosen the flashhider before starting to drive out the reward take down pin for further disassembly.
both guns seem to have the same internals, so i was wondering if i damage the walther/umarex HK 416 if i don't loosen the flashhider before further diassembly or not.
why do i have to loosen the FH on the walther/umarex colt M4 and not on the walther/umarex HK 416?
best regards
dusty
i own a walther/umarex colt M4 clone in .22 l.r. and also a walther HK 416 clone in .22 l.r.
in the manual of the walther/umarex M4 colt clone i can read that it is a MUST to loosen the flashhider some turns before starting to drive out the reward take down pin for further disassembly.
in the manual of the walther/umarex HK 416 clone in .22 l.r. i can't find a passage that's recommending to loosen the flashhider before starting to drive out the reward take down pin for further disassembly.
both guns seem to have the same internals, so i was wondering if i damage the walther/umarex HK 416 if i don't loosen the flashhider before further diassembly or not.
why do i have to loosen the FH on the walther/umarex colt M4 and not on the walther/umarex HK 416?
best regards
dusty
