Perfect Union banner
1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Can someone please give me a diagram of where to put these trigger shims? I put them one those two round pins on either side of the hammer is this the right place?
 

·
Registered
Joined
·
9,786 Posts
One on either side of the Hammer. I put a half drop of oil on mine. After your trigger job, you can slip in a fired case into the chamber to dry fire to check it out.
 

·
Registered
Joined
·
630 Posts
I put a half drop of oil on mine
cajungeo

Too much oil......should of only been 1/4 of a drop....geeessss
:D
Had to laugh at that. Our armor took apart a Glock....department issued to one of our officers. Ask him how much oil he used on the gun. 1/2 of a drop was the answer. The armor turned the gun up side down. More than a table spoon ran out on his desk. One well oiled weapon..I must say...........:eek:
 

·
Registered
Joined
·
9,786 Posts
Speaken of oil, I spilled more than that on my garage floor today, as I changed the oil in my truck. I will be heading to The Astro Dome tomorrow for a large gun show. Will be on the look out for some 10/22 stuff, as will as other stuff. It is a large show, about 2000 tables of gun stuff, but they don't allow any ammo. Wish they did.
 

·
Registered
Joined
·
9,786 Posts
Doeh! I just dug up my invite, the gun show is next week end.
 
1 - 5 of 5 Posts
Top