Perfect Union banner
1 - 4 of 4 Posts

· Registered
Joined
·
2,113 Posts
Discussion Starter · #1 ·
I remember a few years back I saw an aftermarket takedown pin that acts like a wedge between the upper and lower. Has anyone else ever heard of this or seen one?

:sniper:
 

· Registered
Joined
·
2,113 Posts
Discussion Starter · #3 ·
He's tried the accuwedge but it won't close with it in the lower. There's not a lot of play when it's together, I mean very little, but when it's open for cleaning, there's a lot of play on the front pin. I figure that if there's minimal play when you're firing it, it should be ok. I've never tried to fire mine when it's broken down for cleaning. :D


:sniper:
 

· Registered
Joined
·
2,113 Posts
Discussion Starter · #7 ·
We put the pin from Bushmaster in the rifle today. It tightened up everything. He was actually looking for a front pivot-pin, my fault on the terminology. This took care of the slight play in the rifle.

:sniper:
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top