So I loaded up some LEE 155gr. G/C bullets.
17.0, 18.0, 18.5 and 19.0 gr. of IMR 4198
All loads cycled the action fine, which kind of surprised me with the lower end load.
Accuracy was not great though, about 2.5" at 50yds. average.
I do believe my horrid trigger played a big role in this...
Well, I already had one of those cheapy bolt cover mounts laying around, so I thought what the heck try to fit it.
It was a fail again as I have had these in th past and never been able to get a tight fit.
Anywho, Thinking about installing a Choate Mount.
Or maybe a Mojo Rear Peep sight.
Is there anybody home?
There has been Zero activity here.
Well, I am just recoving from Covid, going to try to go back to work tomorrow.
Still not there so be a few weeks I am sure before I get to the range.
However I am going to load up some cast loads in the mean time.
Figure I will...
ALL the small, Allen head screws holding the feet were removed and tightened-down with Loc-tite applied. The screws holding the brackets for the leg-adjustment levers required the lever pivot pins be driven out for access. Once the screws were properly tightened, with loc-tite, and the roll pins...
would like to refinish the stock but there's one pretty good ding and several smaller. anyone know if a hot tank soak could remedy the dings?
it's an arsenal rebuild, #s don't match but I'm gonna do the facelift It shoots unbelievably good with silver bear, 4x NC glass.