I finally picked up my SCAR stock today. Great stock, well worth waiting 2 years for it to come to europe
But now there comes the problem. I tried to put in my 195 serie Ranch Rifle and it just wont go down all the way. I could not engage the trigger mechanism.
So I read the instructions again on the Clyde Armory website and gave it another try.
Not working again.
As I looked closely into the stock I saw sliding marks where the lower receiver fits in. And the same marks an the receiver itself. So I took my dremel with a polishing wheel and polished the surfaces of my receiver. :wacko:
Yeah scary I know but I was carefull not to take any material away. I really just polished the surface.
I tried again but again no use. The receiver just didn't go all the way down. Next step was spraying some gun oil into the stock where the receiver settles.
The result was better but not enough. Still no way getting the trigger in. Again some polishing and the last 2mm were done by a rubber hammer. Now I could engage the trigger and the gun seems to fuction fine.
Question is : Did anyone have similar problems with the SCAR ?