[elkslayer4x5]

I've been looking for a set of 280 Rem Ackley Improved dies and while there are some sets avaible I was wondering if its possible to use a chamber reamer to ream the dies as well as the chamber? Anyone had any experience with this sort of work? All feedback/information will be welcome.

 

[elkslayer4x5]

It would mechanically be possible-but maybe not accomplished if the dies are super hardened!
Huh .280 AI-should be about equal to 7mm rem mag, yes/no?:blink:

Almost, but not quite, but still a very 'huntable' round. The .280 Rem/7MM express is very similar to a 270. Win, but handles heavier bullets better, still flat shooting, and the AI version adds approximatly another 100 fps with the same bullet.