problem getting ejections

1371 Views 8 Replies 4 Participants Last post by New Guy, Mar 15, 2003

doonnzl

Discussion Starter · Mar 12, 2003

http://www.perfectunion.com/forums/showthr...ghlight=ejector

further to this thread..... would a sticky magazine (Dirty or with a weak spring) cause ejection problems? My mags are cleanish, but I may have the tension a bit loose, and they arent worn.

sometimes (about every 3rd or 4th round) the old case is caught up in the works and the bolt tries to close up on it and the round being chambered.

After reading about the ejector in the mag I had to have a look and sure enough the mag spits it out before the ejector on the trigger group. Would a lack of push from the next round cause a case to pop up but not out?

A bolt action semiauto pieces me off

Save

1 - 1 of 9 Posts

New Guy

· #9 · Mar 15, 2003

I used to take those things apart but this is what I do now that works really good and only takes about 30 seconds per mag. I can't take credit for this, a friend told me about it.

Spray carb or brake cleaner into the mag real good then blow it out with compressed air. Spray WD40 into the mag and blow that out with compressed air too.

My mags never worked so good, even the "mag from hell" that was always a problem.

Save

1 - 1 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month