Perfect Union banner
1 - 5 of 5 Posts

·
Registered
Joined
·
72 Posts
Discussion Starter · #1 · (Edited)
Ordered 2 10 round mag from ruger on 1/21/13, Got them on on March 6 2013.
Both mags refused to accept the first round. unless I pushed the Follower to the front edge on the mag. A little bending of the part of the spring that goes
through the hole in the follower twards the front (Bullet Point) end of the mag.
Fixed it. I hope this helps somebody else.
TFL
 

·
Registered
Joined
·
28 Posts
Don't know, I am going to the range tomorrow (Thursday).
I wasn't planning to test them, as I have never had a problem with Ruger magazines.

But you can bet I'll test them now !


Charlie
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top