[RJBurns]

Does anyone know of someone who could permanently install a flash hider or muzzle brake on a preban stainless Mini - 14 ? Thanks - Bob

 

[bushwack]

RJ---Any gunsmith should be able to do the job for you. There's not that much to it unless the suppressor or brake has it's own sight & even then it's simply getting a verticle alibnment of the sight & silver soldering it in place.

Good luck
Bushwack

 

[RJBurns]

I guess the next question is, can any of the muzzle brakes or flash hiders that can be installed using the roll pin be soldered to make it permanent? If not does anyone know who sells the type I need? Thanks for your help - Bob

 

[mikr]

Originally posted by RJBurns
Does anyone know of someone who could permanently install a flash hider or muzzle brake on a preban stainless Mini - 14 ? Thanks - Bob

If it is a "pre-ban", then why would you want it permanently attached, and why go through the added expense if only "postbans" really require that they are permanent?

 

[cajungeo]

Check with DRC, and ASI in Colorado.

 

[mikr]

I just got your PM---as far as permanent installs, I don't know, but I see why now you are doing so----I do not know of anyone except for Bill Wilson who does great jobs for that, but his are for AR's....sorry man. Will keep eyes and ears open though.

 

[bc_ca]

it was a masen blackwarrior brake. The darn thing fits way too lose I could wiggle it with the pin in!! on my mini ranch model 196-. It slung rounds like all over the place just like some new mini's do straight from the box. All I had to do was just remove it and throw it in the bottom of the ammo can and i got my groups back...
the brake / flash suppressor is in my case not a worthy purchase.
but understand my mini is hitting 2" boiler plates at 200 yards scoped 3 out of 5 five times. benched.
just goes to show sometimes too much is just too much.
enjoy your mini
later
bc
>):2guns: