Perfect Union banner
1 - 7 of 7 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
I was doing some plinking the other day and after about 20 rounds I noticed something missing. The stock reinforcement screw and lock washer were missing on one side. Unfortunately I was in tall grass so there was no hope of finding it without a metal-detector. I looked up the part number and price on Ruger's site: 50 cents apiece.

I guess I will have to lock-tite those before I go out again.
 

·
Registered
Joined
·
198 Posts
chuck-slayer,

You might also want to order a few magazine followers #MS0300,$1.25 ea. to repair your ruger mag and fix up a few more aftermarket hi-caps.
 

·
Registered
Joined
·
689 Posts
I've lost'em before also. I found some counter sunk metric allen heads at a local hardware store. Loctited them and no more problems.
 

·
Registered
Joined
·
135 Posts
How would installing a Ruger Follower improve an aftermarket mag? Also ,can someone post a link to the site where you can buy parts for your mini?
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #6 ·
How would installing a Ruger Follower improve an aftermarket mag
I have a thread in the Magazines forum that sort of explains this.

It worked for me, your mileage may vary.
 

·
Registered
Joined
·
1,071 Posts
I lost mine out on the range as well. Call Ruger first, and ask for them. They sent me 2 sets of replacement screws and washers free. The customer service is usually pretty good.

TC:rapid:
 
1 - 7 of 7 Posts
Top