Perfect Union banner
1 - 6 of 6 Posts

· Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
I put in a longer firing pin, took it to the range and it won’t chamber a round. I’ll try to take the dang thing apart tonight and see what is wrong but I swear I reassembled the rifle correctly. Any ideas what could be wrong? When I looked at it in the field it seemed like the bolt wasn’t coming back far enough. It dry-fired ok. Mag was inserted properly.
 

· Registered
Joined
·
84 Posts
Does it load a round when you fully retract it? Is it not stripping the next round or is the round "hanging up" and not fully feeding?

Check your fp protrusion. Is the rim of the case catching on the tip of the fp?
 

· Formerly "raf"
Joined
·
4,266 Posts
Would it be possible to paint one side of the op rod spring guide RED for "Stop" and the other side "GREEN" for "Go"? I realize it's better to memorize this re-installation procedure, but since it is not often done, perhaps a little "help" to one's memory is in order?
 
1 - 6 of 6 Posts
Top