Perfect Union banner
1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Hi Everyone

I am considering buying a Millet RM14001 rear sight for my 182 series Stainless Steel Mini-14

I have a few questions about this sight:

1. Do I have to drill and tap the receiver to fit it?
2. I am currently using a Choate flash hider with M14 style front sight - will this sight be at the correct height for the Millett rear sight?

Thanks for your help and advise

Aus
 

·
Registered
Joined
·
217 Posts
I have a millet rear sight on my mini, no drilling/tapping required. The factory peep is removed and the Millet goes in its place. Although I havent done any shooting at paper for groups, it doesnt wobble like my factory peep did so maybe a slight increase in accuracy. It's easier to adjust than the factory peep. I have an Eagle HK style sight/flashider and surprisingly after installing the sight it hardly changed the zero at all. Good luck.
-Grinch
 
1 - 2 of 2 Posts
Top