Perfect Union banner
1 - 7 of 7 Posts

·
Registered
Joined
·
1,200 Posts
Discussion Starter · #1 ·
Without pulling a scope of mine, I wonder if any here has theirs off and can answer for me. How wide are the scope bases on the receiver of the Mini 14 Ranch, and also how long they are, and how far inside to inside, they are apart.

Lots I know, but would be appreciated.

I am referring to the built in part that Ruger makes you attach the rings to.

Thanks
 

·
Registered
Joined
·
72 Posts
.495" is the width and 4.04" is the length measured to the outside of the bosses.
This is on a 580 series. I had it written down, so taking further measurements will require some time and effort, but can be done later.
 

·
Registered
Joined
·
1,200 Posts
Discussion Starter · #3 ·
jim580
Thanks. I am thinking of building a one piece scope rail that will cover both spots on the rifle, for scope attachment, and lower it considerably.
 

·
Registered
Joined
·
182 Posts
handrifle: Have you looked at the Weigand or GG&G rails? They're both very high quality and made from aircraft aluminum so they're as light as possible. Here's a picture of my 582-series Mini-14 Tactical with Weigand rail and UTG 3-9 X 32 MM CQB scope:



Quinton
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top