Perfect Union banner
1 - 4 of 4 Posts

· Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
I am using a Kimber Ultra Carry CDP and while training the aluminum checkered back strap is digging into the pinky side of my palm and after 500 rounds it almost digs a hole in that cushioned side of the palm.

My question is, should I train the grip to go into the seam of the palm, have a softer back strap installed or just shut up and take it like a man?

Any suggestions would be greatly appreciated (except the "shut up..." part) as well as offers to take this gun off my hands for a Glock 30 + other gun.

Thanks in advance,

Paul
 

· Registered
Joined
·
533 Posts
I would first have someone check my grip. If your grip is good try a different set of grips with palm swell (Hogue and several other mfgs make them and they aren't expensive).
 

· Registered
Joined
·
285 Posts
I am not sure if the Ultra Carry you have has a alloy frame. If so the recoil is going to be somewhat sharp with the 3 inch barrel. Those little guns will recoil for sure and I would only suggest that you try using lighter loads or shoot fewer rounds to keep your hand from being battered.
 

· Registered
Joined
·
72 Posts
gun for nearly all their practice firing. That saves the wear and tear and fouling on the carry gun. It doesn't matter if the practice gun breaks,or is filthy. So you dont have to waste so much time cleaning it after every session at the range. Make it a 9mm, alloy Commander or compact, for the cheaper ammo. You wont regret it.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top