Perfect Union banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi guys I am new here and hope that you can help me with my mini ranch.I have lapped the gas block and have reduced my group size from 6"in.to less than 1/2" @ 25yrds.with wolf ammo 55gr.(4rounds).Ihave worked the stock near the gas block and removed the metal ring.I did not remove the tabs on the gas block.I also trimmed the barrel shroud as the rivet was touching the barrel.I installed a recoil buffer but had to trim it a little as it would cause the the reciever to lift about 1/8" off the stock then i removed the trigger assy.the gun shoots ok and everything works the way it should.So whats wrong it shoots 6 to 8"inches low and I can't raise the rear sight any highter.these are the factory rear peep sight.Any Ideas?????.
steve
 
1 - 2 of 2 Posts
Top