Perfect Union banner

Front Sight on New Mini 30

2K views 4 replies 5 participants last post by  Rainman_GA 
#1 ·
Does anyone know how I can remove the front sight on my new Mini 30? I punched out the roll pin with no problems, but this thing must be welded on.... Any suggestions?
 
#5 ·
Mine was on so tight that I had to take a Dremel cutoff wheel and cut partway through the sight sleeve lengthwise (next to the ramp). Then put a thick cold chisel in the cut and tapped it with a hammer until the sleeve split along the cut. Left no marks and popped right off!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top