Perfect Union banner
1 - 5 of 5 Posts

·
Registered
Joined
·
271 Posts
Use a wood block, heavy hammer, & lube.....
 

·
Registered
Joined
·
22 Posts
Did you get the front sight off and do you have a picture of what it looks like afterwards? I'm thinking of doing the same but want to see what I have to work with afterwards.
 

·
Registered
Joined
·
3 Posts
Mine was on so tight that I had to take a Dremel cutoff wheel and cut partway through the sight sleeve lengthwise (next to the ramp). Then put a thick cold chisel in the cut and tapped it with a hammer until the sleeve split along the cut. Left no marks and popped right off!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top