Perfect Union banner
1 - 5 of 5 Posts
G

·
Discussion Starter · #1 ·
What is the best way to get the roll pin on the front sight out is there any trick or will a punch and a hammer do it?
 

·
Registered
Joined
·
716 Posts
I just set the barrel on a 2x4 on a carpeted floor and holding the rifle, use a nail-set or even a nail of the right diameter, and a hammer and just drive it right through. You aren't gonna hurt it, unless you get out of control. ;)
 
G

·
Discussion Starter · #3 ·
cool thanks for the reply I just wanted to double
check to make sure I don't mess it up! I guess
that is hard to do with a mini though!
 

·
Registered
Joined
·
685 Posts
i used a allen wrench that just covered the surface of the roll pin and tapped it out and it don't hurt to use kroil or thurst either. just another way to look at it...later
 
1 - 5 of 5 Posts
Top