[hanksr]

I just took the trigger off my 10/22 the little metal piece that fits in the forward slot is stlightly bent on the tip. Is this normal? what problems would it cause? Thanks

Ryan

 

[cajungeo]

Hey Hanks. You are refering to item B-8. It is the ejector. It is only used to eject, a round if the mag is out of the rifle. If yours is bent, Raise it up, and straighten with a pair of duckbill or needle nose plyers (jaws taped so as not to scratch), and straighten it. Or if you have an anvel on the back of a vice or other hard flat surface, lay it flat and tap out flat with a hammer. Debur any burrs. Make shure it dosent bind up in the slot. Reasemble your rifle, your good to go.
http://www.ontargetguns.com/1022.pdf

 

[hanksr]

That's exactly the piece I was talkin about thanks for the info cajun.


Ryan Hanks