Perfect Union banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Just want to say hello to the individuals of this forum and glad to be back reloading. I have little experience must from reloading with my father as a kid. So, still a novice.

One thing I want to ask up front! Looking at different load data manuals I find that things like trim length differ. Am I good as long as a stay with in the parameters for that casing and have even trim lengths? Also, data on the min trim length is not always there, just length to trim to.
 

·
Registered
Joined
·
833 Posts
usually you can figure a couple thousandths less than the "trim to" length for MINIMUM length...

I would go with CURRENT manuals for current trim to lengths... and in case of a discrepancy... if 3 say one thing and a 4th says something different... I would probably go with the majority rule... :)
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top