Perfect Union banner

Anyone use a roll pin for gas bushing?

3520 Views 13 Replies 11 Participants Last post by  7.62x39
I saw where someone used a 3/32 roll pin for a bushing. What do you think?
1 - 1 of 14 Posts
if shooting from a bench for accuracy testing is a concern tap the gas pipe for a short set screw which effectively makes the mini a straight pull bolt action. tough to tap the pipe so use good quality tap and lots of lube if you try this. easily reversed.
saves the brass from dings too.
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.