Perfect Union banner

Anyone use a roll pin for gas bushing?

3517 Views 13 Replies 11 Participants Last post by  7.62x39
I saw where someone used a 3/32 roll pin for a bushing. What do you think?
1 - 1 of 14 Posts
We all see the dents. I remember someone ground down the sharp corner of the Slide Handle where the brass hits. Not sure if that cured the dents or not though.
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.