Joined
·
10 Posts
To pull the 1998 Stainless Ranch Rifle out and to start a dedicated job of accurizing and tricking it out.
I have UTG triple rail clamps coming and have a couple of questions: 1st- for the strut rod, is there a preference between mild steel, high carbon steel, aluminum, etc. 2nd- Is there any proven theories and/or evidence that drilling the rod and filling it with a substance would be beneficial?
Also, is there any additional integrity gained if one cuts the end if the rod to fit around the webbing on the gas block and then drilling and inserting a roll pin?
Brad
I have UTG triple rail clamps coming and have a couple of questions: 1st- for the strut rod, is there a preference between mild steel, high carbon steel, aluminum, etc. 2nd- Is there any proven theories and/or evidence that drilling the rod and filling it with a substance would be beneficial?
Also, is there any additional integrity gained if one cuts the end if the rod to fit around the webbing on the gas block and then drilling and inserting a roll pin?
Brad
