Perfect Union banner
1 - 1 of 7 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I am full length resizing 6.5x55 cases from factory S&B & Federal rounds fired from a modern sporting Husqvarna rifle and am finding wide variations in case length before resizing...a gap of up to .020" from brand to brand. After resizing, each case is growing about .005 to .006" in length. I have measured my chamber length and finding some of the once fired cases difficult to close a bolt on. I'm resizing to 2.150". Haven't test fired the reloads yet.

What amount of case length expansion is normal after FL resizing once fired factory ammo? I'm using Redding FL dies. I appreciate any responses. Thanks
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.