Perfect Union banner

1 - 4 of 4 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter · #1 ·
Has any one put something like this on,
What rings did you use?
How did you resolve the turkey necking to get a good cheek weld?


Unable to post pic of this ,but I think there are a bunch that know of this situation..
Thx
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #2 ·
Does M c Millian or other make a better stock for this?

Similar to some I have seen for the M1A?
google fued out,my eyes hurt.
 

·
Registered
Joined
·
2,542 Posts
You need rings with a minimum height of 6mm, or .236". IIRC, Warne's low rings have a height of .250". Keep in mind, though, that you may have clearance issues with your rear sight...

As for the cheek weld, there are several cheek rests that folks have installed, with the Karsten probably being the most popular around here. I know that Revolution makes a laminate stock with a Monte Carlo-style comb that should help a bit...
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #4 ·
Thx and will try and keep up with the info posted..

I used the warne 30 mm q d,and am very disappointed over all so far....
 
1 - 4 of 4 Posts
Top