Being that I have mine apart for refinish I had a couple of thoughts.
1) Has anyone tried bushing with a close tolarance sholder bushing where the barrel goes into the receiver?
2) I noticed where my forward scope mount hole is Ruger went all the way threw and dimpled inside whe area where the barrel sits. What about drilling the rest of the way threw and installing a set screw? This would act like the gunsmith block but be more secure.
3) Also the barrel extends quite a bit threw the receiver. Is there a tolorance or benifit to spacing this differently?
1) Has anyone tried bushing with a close tolarance sholder bushing where the barrel goes into the receiver?
2) I noticed where my forward scope mount hole is Ruger went all the way threw and dimpled inside whe area where the barrel sits. What about drilling the rest of the way threw and installing a set screw? This would act like the gunsmith block but be more secure.
3) Also the barrel extends quite a bit threw the receiver. Is there a tolorance or benifit to spacing this differently?