Perfect Union banner

10/22 torqe setting, stock bolt

992 views 2 replies 2 participants last post by  holeshot308 
#1 ·
Finishing up two 10/22 that have full pillars installed in the stocks. Need to find out what the stock screw needs to be torqued to in in/lbs. Appreciate any info here on a starting point for torqeing these screws, thanks in advance, holeshot308
 
#2 ·
Start at 25 inch/lbs but your sweet spot can be anywhere from 22-30. I have 3 10/22s and they all are different I wouldn't go more than 30 because the screw threads into aluminum.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top