Got my parts kit

[93sr20det]

I got my Imbel parts kit yesterday. Bore is very bright and shiny with tons of riffling left. It looks like I may have gotten a training gun because there is wear all over the gun but it looks like it was fired maybe a handful of times. Since it was a military gun I got an all steel lower which I am excited about. I spent about 2 hours last night removing what seemed like axle grease from the parts. It did not smell like cosmoline and was very oily and runny. Also I am having problems with a stuck gas regulator. I hosed it down with PB Blaster last night and I am going to spray it again before I leave work work. I'll post pics tonight after I finish with the cleaning.

[93sr20det]

I managed to get the gas regulator off. I had to soak it in PB Blaster for almost 24 hours and then I used a punch and hammer to spin it off. Other than that disassembly went flawless.


http://lh3.google.com/93sr20det/R6vUqFo7gBI/AAAAAAAAAiQ/30HAqz0VQi0/s800/IMG_0336.JPG
All I need is a receiver...


http://lh6.google.com/93sr20det/R6vU51o7gCI/AAAAAAAAAiY/7-V2rijUFhs/s800/IMG_0340.JPG
Bright bore coming at you!

I think I have decided on getting a DS Arms receiver over the Enterprise Arms because of alot of mixed reviews with the Enterprise. I was going to go with an Imbel receiver but they are expensive and hard to find.

[rapid223fire]

Alex... Nice kit

I have a barrel vice you can use, so if you can locate the headspace stuff and tools needed I will help you build it. Also, I have an Imbel FAL you can use for refernces.

[93sr20det]

I am going to get my tools from here (http://gunthings.com/faltools.htm)

$38 for the pair of headspace gauges
$29 for the locking shoulder gauges
$57 for the receiver wrench
$75 for a barrel vice (I'll need it in the future)
$200 Total for tools



$60 for the Gunplumber Dvd set from Arizona Response Systems (http://www.arizonaresponsesystems.com/store/storemisc/pagestoremisc.htm)