rutro
01-16-2007, 21:50
I'm not going to say where I learned this, but it sure works good. Started out with a peice cut from a scrap of sch.40 PVC 3/4'' O.D. and about 1/4'' wide. Cut that in half so you end up with a half circle. Trim this to the legnth of the trigger. Then use the dremmel and a small cut off wheel to start a slot around the outside of it the same width as your trigger. Then with the dremmel and an attachment of choice widen the slot to the depth of the triggers thickness or a little less. I used a 1/8''zipp bit and cleaned it right out. Then finish shapeing with a small drum sander and paint with Krylon Textured....... color of choice and attach with some DAP contact cement. If the circle of PVC isn't quite the right diameter you can heat it very quickly over a flame, not to close it'll burn fast, and when just soft press onto the trigger and let cool. Do this before painting of course......;) Made my 3.5lb. pull feel like 2lb.