FALer's FAL

[FALer]

:usa:
I've had this one built for almost three years now. It's killed Texas turkeys and many a paper target.

1. Entreprise Type 3 receiver (no carry handle cut).
2. R1 parts kit (Wholesale Gun).
3. Tapco U.S. furniture parts kit (STG-58), U.S. muzzle break, U.S. stainless gas piston, U.S. aluminum cocking handle.
4. Inch bolt carrier (It's the cool one with the sand cuts).

Other mods:
1. Teflon tape around the gas tube where it screws into the gas block for reliability.
2. Barrle cut to 17.5".

It's definately a truck gun..... But I love it. It's got alot of Krylon on it....And still pumps 'em out, accurate too (fist sized prints @ 100 yards with FMJ's).

[FALer]

Another Pic.

[adaman04]

Very nice. Like that shorter barrel.

[FALer]

Thanks. I cut it to 17" with a hack saw then wallered out the threads on that tapco muzzle break and pinned it to the end. Works for me.

:usa:

[AR15_Fanatic]

Yeah, that is a nice little rifle.

Have one on me!

:usa: :beer: :usa:

[FALer]

Thanks. Don't mind if I do.

:usa:

[RoosterTac]

Are you sure that it's an Entreprise Type 3 receiver and not an Imbel Type 3? Up until this past year, Entreprise did not make a Type 3 but they did sell the Imbel Type 3.

[FALer]

I've seen Imbel Type 3's. This one doesn't have any markings whatsoever to lead me to believe that it is an Imbel. It says Entreprise Arms STG-58C on one side and the serial number on the other side.... I bought it back in 2001. It was sold to me as an American made product so that's what I'm gonna go with dude...


:usa: