My Mini-14 Gun Porn :)

[Desperado]

[FONT=Geneva][SIZE=7]Hello. I'm been "lurking" about on this site for quite some time and have found it to be very helpful in getting my Mini-14 all ready for show. Here's a couple of pictures of it. Yes, that is a 3-prong flash hider on the front. Haven't had a chance to shoot it with that installed yet but really looking forward to the first testing. And, yes, it is a pre-ban B)

Let me know what you think.

Dave

[Desperado]

Here's the next picture of the flash hider (a little closer for drooling purposes)

[minimeister]

:usa: That Mini's got it goin on! Luv that BC folder. I got the same stock. Can I still see threads on your barrel,behind the flash hider? Lemme know.

[Desperado]

No, I wish it was threaded on there. I searched high and low for the right tap and die set to no avail. So, I VERY carefully reamed it out. Milimeter by milimeter with my dremmel :unsure: until it fit just so. I must have hit it with the dremmel and tested for fit over 100 times. Finally got it where it needed to be and had my brother-in-law spot weld in on in three places. What you are seeing is a bit of the weld I haven't had time to dremmel down. I was so excited that I got it done, I had to post it! I've been driving my wife crazy for the entire day!!

Hope that answers your question. After I get it taken down to nearly invisible, I'm going to blue the weld and I'll have to put another pic on.

[cajungeo]

Welcome to the forum Desperado. Nice pre-ban. I like the flash hidder.

[boogeyman]

Nice Mini! I dig the SP1 hider and how you rigged your 6P :beer: You might want to get a Z32 bezel for the 6P, it has a shock isolation ring inside to save the lamp assembly. I think it's under 20 bucks. Call Dan @ tactical warehouse 1 888 505 plan tell him Josh sent you and he will take care of you.