Dave3006
01-13-2002, 17:18
I had a bad start testing my Promag 10 rounders. I have two minis and one was having extraction problems. Today I brought the mags to the range with my other Mini-14. I shot about 120 rounds through 10 magazines. Here's what happened:
I loaded all of the mags with 10 rounds. 9 functioned flawlessly. Not even a problem getting the first round to feed as I reported earlier with my other Mini-14. One of the mags, I had a problem with the last round, it stovepiped pretty bad. It actually bent the round. I tried it again with 10 more rounds, another jam. Then, I pushed the follower up and down several times to see if it was catching on anything. I loaded it with 10 more round two more times. No problems.
Would you keep these? My only fear is that I will see this come up on the other mags too. Maybe I just got luck? Any input?
I loaded all of the mags with 10 rounds. 9 functioned flawlessly. Not even a problem getting the first round to feed as I reported earlier with my other Mini-14. One of the mags, I had a problem with the last round, it stovepiped pretty bad. It actually bent the round. I tried it again with 10 more rounds, another jam. Then, I pushed the follower up and down several times to see if it was catching on anything. I loaded it with 10 more round two more times. No problems.
Would you keep these? My only fear is that I will see this come up on the other mags too. Maybe I just got luck? Any input?